Removal Procedure
CAUTION:
Refer to SIR Caution
in Cautions and Notices.
- Remove the IP (Instrument Panel) upper trim pad. Refer to Trim Pad Replacement - Instrument Panel (I/P) Upper (Standard Models) or Trim Pad Replacement - Instrument Panel (I/P) Upper (WC2/WC8) .
- Remove the IP cluster trim panel. Refer to Trim Panel Replacement - Instrument Panel (I/P) Cluster .
- Remove the IP storage compartment. Refer to Storage Compartment Replacement - Instrument Panel (I/P) .
- Remove the screws securing the right IP accessory trim panel (1) to the IP.
- Partially remove the trim panel (1) in order to disconnect the hazard switch electrical connector.
- Remove the right accessory trim panel (1).