Installation Procedure
- Connect the electrical connector to the hazard switch.
- Install the right accessory trim panel (1).
- Install the trim panel screws.
Tighten: Tighten the screws to 2 N.m (18 lb. in.).
- Install the IP cluster trim panel. Refer to Trim Panel Replacement - Instrument Panel (I/P) Cluster .
- Install the IP storage compartment. Refer to Storage Compartment Replacement - Instrument Panel (I/P) .
- Install the IP upper trim pad. Refer to Trim Pad Replacement - Instrument Panel (I/P) Upper (Standard Models) or Trim Pad Replacement - Instrument Panel (I/P) Upper (WC2/WC8) .
NOTE:
Refer to Fastener Notice in Cautions and Notices.