Aiming Procedure

Remove any snow, ice, or mud from the vehicle.
Align the vehicle left tires with the reference line extending from the screen with the headlamps aligned with the reference line.
Stop all unnecessary operations or work on the vehicle that affects the vehicle trim.
Completely assemble all the components to the vehicle.
The vehicle should have cargo or loading representative of normal vehicle use.
Close the doors.
Verify that the tires are inflated to the proper tire pressure.
Rock the vehicle sideways to stabilize the suspension.
Measure from the reference line on the floor to the left headlamp bulb aim dot on the headlamp.
At the screen, measure from the reference line on the floor and place the vertical tape at the measured distance.
Measure from the reference line on the floor to the right headlamp bulb aim dot on the headlamp.
At the screen, measure from the reference line on the floor and place the vertical tape at the measured distance.
Measure between the left and right headlamp vertical tape on the screen.
Divide the measured amount in half and mark on the screen. This is the centerline of the vehicle.
At the screen, measure from the floor and place the horizontal tape at 61 cm (24 in).
Measure 88.9 mm (3.5 in) left of the center line and mark on screen.
Hang a trouble light along the aiming screen at the measured location.
Cover the windshield with a fender cover or equivalent.
Turn on headlamps and night vision.

IMPORTANT: When aligning night vision camera leave a 1 mm (0.04 in) minimum clearance between the camera and the secondary hood latch rivet.