Removal Procedure
- Remove the IP upper trim pad. Refer to Trim Pad Replacement - Instrument Panel (I/P) Upper (Standard Models) or Trim Pad Replacement - Instrument Panel (I/P) Upper (WC2/WC8) .
- Remove the instrument cluster trim panel. Refer to Trim Panel Replacement - Instrument Panel (I/P) Cluster .
- Remove the 4 fasteners (1) retaining the IP cluster to the IP.
- Disconnect the electrical connectors (2) on each side of the IP cluster.
- Remove the IP cluster (3) from the IP.
CAUTION:
Refer to SIR Caution
in Cautions and Notices.