LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2005 >> DeVille Protection Series >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays, Gauges And Console >> Repair Instructions >> Instrument Panel (I/P) Assembly Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of I/P & Carrier Assembly
    GM474611Courtesy of GENERAL MOTORS CORP.
  1. Install the I/P and carrier assembly to the vehicle.
    2. Fig 2: View Of I/P Carrier Nuts & Bolts
    GM551934Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the nuts and bolts (1,2) to the I/P carrier.

    Tighten:  Tighten the bolts to 25 N.m (18 lb. ft.).

    3. Fig 3: View Of I/P Carrier Cowl Nuts
    GM474609Courtesy of GENERAL MOTORS CORP.
  3. Install the I/P carrier to cowl nuts (1).

    Tighten:  Tighten the nuts to 25 N.m (18 lb. ft.).

    4. Fig 4: View Of I/P Center Support Bracket Bolts
    GM551005Courtesy of GENERAL MOTORS CORP.
  4. Install the I/P center support bracket bolts (1) to the floor bracket.

    Tighten:  Tighten the bolts to 25 N.m (18 lb. ft.).

    5. Fig 5: Identifying Steering Column To Body Bolts
    GM550997Courtesy of GENERAL MOTORS CORP.
  5. Install the steering column bolts (1). Refer to Steering Column Replacement (Floor Shift) or Steering Column Replacement (Column Shift) in Steering Wheel and Column.
  6. For a DeVille base model, or the DeVille DHS, Install the shift cable to the steering column.
  7. Connect the electrical connectors from the steering column to the body.
    8. Fig 6: View Of I/P Electrical Connectors
    GM105537Courtesy of GENERAL MOTORS CORP.
  8. Connect the electrical connectors (1) at the top outside corners of I/P.
  9. Install the heads up display, if equipped with UV8. Refer to Head Up Display Replacement .
  10. Install the I/P upper trim pad. Refer to Trim Pad Replacement - Instrument Panel (I/P) Upper (Standard Models)  or Trim Pad Replacement - Instrument Panel (I/P) Upper (WC2/WC8) .
  11. Install the defroster grille. Refer to Defroster Grille Replacement (Without UV2)  or Defroster Grille Replacement (UV2) .
  12. Install the windshield pillar trim. Refer to Garnish Molding Replacement - Windshield Pillar (Standard) or Garnish Molding Replacement - Windshield Pillar (WC2, WC8) in Interior Trim.
  13. Install the center seat or the center console. Refer to Compartment Replacement - Instrument Panel (I/P) (Base and DHS)  or Compartment Replacement - Instrument Panel (I/P) (DTS)  in Seats, or Console Replacement - Front Floor (DTS without UV8)  or Console Replacement - Front Floor (DTS with UV8) .
  14. Install the left and right I/P outer trim panels. Refer to Instrument Panel (I/P) Outer Trim Cover Replacement - Right  and Instrument Panel (I/P) Outer Trim Cover Replacement - Left .
  15. Install the left knee bolster support bracket. Refer to Knee Bolster Bracket Replacement - Left .
  16. Install the left knee bolster. Refer to Knee Bolster Replacement - Left (Without UV2)  or Knee Bolster Replacement - Left (UV2) .
  17. Install the right knee bolster. Refer to Knee Bolster Replacement - Right .
  18. Enable the SIR. Refer to SIR Disabling and Enabling Zone 3 and SIR Disabling and Enabling Zone 5 in SIR.
scientia non olet · About LEMON Manuals