Installation Procedure

Fig 1: Identifying Console Door Hinge & Screws

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Fig 2: Identifying Armrest Inner Trim Panel & Screws

Courtesy of GENERAL MOTORS CORP.

Install the armrest inner trim panel (2).
Install the screws (1).
Tighten: Tighten the screws to 1.6 N.m (14 lb. in.).
If equipped with UV8, Install the Cellular phone docking station. Refer to Cellular Telephone Docking Station Replacement (DeVille and DHS) or Cellular Telephone Docking Station Replacement (DTS) in Cellular Communications.

Fig 3: Identifying Center Console Tray & Screws

Courtesy of GENERAL MOTORS CORP.

Install the console tray (2).
Install the console tray screws (1)
Tighten: Tighten the screws to 1.6 N.m (14 lb. in.).

Fig 4: Identifying Console Door Hinge & Air Vent Cover

Courtesy of GENERAL MOTORS CORP.

The center console door has alignment pins next to the top 2 hinge screws.
Align the console lid and hinge assembly to the center console.
Install the console hinge screws (1).
Tighten: Tighten the screws to 1.6 N.m (14 lb. in.).
Install the inner auxiliary HVAC outlet (2).
Close the console compartment door.

Fig 5: View Of Floor Console Rear Cover & Screws

Courtesy of GENERAL MOTORS CORP.

Install the center console rear cover (3).
Install the console rear cover screws (1, 2).
Tighten: Tighten the screws to 1.6 N.m (14 lb. in.).
Install the auxiliary HVAC control. Refer to HVAC Control Module Replacement - Auxiliary in HVAC Automatic.
Ensure proper operation of the console door.