Installation Procedure

Fig 1: View Of Insulator Panel

Courtesy of GENERAL MOTORS CORP.

Slide the closeout insulator panel (2) over the top of the emergency brake bracket (1).

Fig 2: View Of Closeout/Insulator Panel & Fasteners

Courtesy of GENERAL MOTORS CORP.

Set the forward edge of the closeout insulator panel (2) on the shelf above the carpeting.
Align the closeout insulator panel (2) with the fastener holes.
Install the push pin type retainers in order to hold the insulator panel in position.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the threaded fasteners (1) to the lower insulator panel.
Tighten: Tighten the fasteners (1) to 2 N.m (18 lb. in.).