LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> Seville >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays, Gauges And Console >> Repair Instructions >> Trim Panel Replacement - Knee Bolster >> Removal Procedure

Removal Procedure

IMPORTANT: The knee bolster trim panel must be replaced, not repaired, if there is any visible damage.
    Fig 1: Identifying Knee Bolster Fasteners & Trim Panel
    GM105514Courtesy of GENERAL MOTORS CORP.
  1. Remove the driver's side sound insulator. Refer to Closeout/Insulator Panel Replacement - Left (LHD)  or Closeout/Insulator Panel Replacement - Left (RHD)  or Closeout/Insulator Panel Replacement - Right (LHD)  or Closeout/Insulator Panel Replacement - Right (RHD) .
  2. Remove the knee bolster fasteners (2).
  3. Remove the knee bolster trim panel (1) by grasping the bolster at the top and the bottom. Pull the bolster downward in order to disengage the snap clips at the rear of the trim plate.
scientia non olet · About LEMON Manuals