Installation Procedure

Fig 1: Identifying Left & Right DIC Switch Electrical Connectors & IP Cluster Trim

Courtesy of GENERAL MOTORS CORP.

Install the DIC switches to the IP cluster trim panel. Refer to Driver Information Center Switch Replacement .
Engage the lower edge of the IP cluster trim plate (3) to the IP.
Connect the two electrical connectors (1,2) to the DIC switches.

NOTE: Refer to Fastener Notice in Cautions and Notices

Install the two screws from the trim panel to the IP retainer.
Tighten: Tighten the screws to 2 N.m (18 lb in).

Fig 2: Identifying Cluster Trim Panel to Passenger Trim Panel Screw

Courtesy of GENERAL MOTORS CORP.

Install the screw securing the IP cluster bezel to the passenger trim panel.
Tighten: Tighten the screws to 2 N.m (18 lb in).
Install the Upper Trim Pad Trim Pad Replacement - Instrument Panel (I/P) Upper .