LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> Seville >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays, Gauges And Console >> Repair Instructions >> Ignition Switch Replacement (RHD) >> Installation Procedure

Installation Procedure

    Fig 1: Identifying Ignition Switch Fastener
    GM751049Courtesy of GENERAL MOTORS CORP.
  1. Install the ignition switch (2) to the I/P retainer.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Through the opening next to the steering column, install the ignition switch fastener (1).

    Tighten:  Tighten the fastener to 2 N.m (18 lb in).

    3. Fig 2: Identifying Ignition Lock Cylinder Release Button & Ignition Switch Assembly
    GM751050Courtesy of GENERAL MOTORS CORP.
  3. Through the I/P outer trim panel opening, install the ignition switch fasteners (1, 4).

    Tighten:  Tighten the fastener to 2 N.m (18 lb in).

    4. Fig 3: Identifying Park Lock Cable
    GM339237Courtesy of GENERAL MOTORS CORP.
  4. Install the park lock cable (1) to the ignition switch.
  5. Connect the ignition switch electrical connectors.
  6. Install the lamp socket to the ignition switch.
    7. Fig 4: Identifying Ignition Lock Cylinder
    GM291659Courtesy of GENERAL MOTORS CORP.
  7. With the key installed in the ignition lock cylinder (1) insert the ignition lock cylinder (1) into the I/P opening (2).

    The lock cylinder retaining tab (3) will produce an audible click, when fully engaged.

  8. Using light force, pull on the lock cylinder in order to ensure the lock cylinder is engaged.
  9. Turn the ignition to LOCK, then remove the key.
  10. Install the right I/P outer trim panel. Refer to Instrument Panel (I/P) Outer Trim Cover Replacement .
  11. Install the knee bolster. Refer to Knee Bolster Replacement .
  12. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 9 in SIR.
  13. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
  14. Inspect the ignition switch for proper operation in all positions.
  15. Release the park brake.
scientia non olet · About LEMON Manuals