LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> Seville >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays, Gauges And Console >> Repair Instructions >> Console Replacement (w/o UV8) >> Installation Procedure

Installation Procedure

  1. Position the console assembly on the floor in the vehicle.
  2. Connect the console electrical connectors.
  3. Lift up on the rear of the center console and slide the center console (1) forward in order to align the front edges of the center console with the lower I/P.

    Place the rear of the center console (1) onto the rear studs.

    4. Fig 1: Identifying Console to Lower Instrument Panel Fasteners
    GM105563Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the 2 fasteners (2) from the center console (1) to lower I/P.

    Tighten:  Tighten the fasteners (2) to 2 N.m (18 lb in).

    5. Fig 2: View of Metal Bracket Arms to Floor Fasteners & Console Rear to Floor Pan Nuts
    GM105564Courtesy of GENERAL MOTORS CORP.
  5. Install the 2 nuts (2) to the floor studs in the center console compartment.

    Tighten:  Tighten the fasteners (2) to 10 N.m (89 lb in).

  6. Install the fasteners (1) to the metal bracket arms on the console.

    Tighten:  Tighten the fasteners (1) to 10 N.m (89 lb in).

    7. Fig 3: Identifying Center Console Electrical Connectors
    GM105560Courtesy of GENERAL MOTORS CORP.
  7. Connect the electrical connectors (1,2,3) on both sides of the console.
    8. Fig 4: View of Storage Bin Floor Cover
    GM105557Courtesy of GENERAL MOTORS CORP.
  8. Install the cover (1) to the floor of the storage bin.
  9. Install the park lock cable to the shifter. Refer to Park Lock Cable Replacement (LHD) or Park Lock Cable Replacement (RHD) in Automatic Transaxle-4T80-E.
  10. Connect the shift cable to the shifter. Refer to Automatic Transmission Range Selector Cable Replacement in Automatic Transaxle-4T80-E.
  11. Install the left console panel. Refer to Console Trim Panel Replacement - Left .
  12. Install the right console panel. Refer to Console Trim Panel Replacement - Right .
  13. Install the console trim plate. Refer to Trim Plate Replacement - Console .
  14. Install the storage bins or the CD changer as needed. Refer to Console Storage Bin Replacement  or Remote CD Changer Replacement in Entertainment.
  15. Enable the SIR. Refer to SIR Disabling and Enabling Zone 7 and SIR Disabling and Enabling Zone 9 in SIR.
scientia non olet · About LEMON Manuals