Installation Procedure

Fig 1: Identifying Console Door Hinge & Screws

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Fig 2: Identifying Armrest Inner Trim Panel & Screws

Courtesy of GENERAL MOTORS CORP.

Install the armrest inner trim panel (2) to the armrest.
Install the screws (1) to the armrest inner trim panel (2).
Tighten: Tighten the screws to 1.6 N.m (14 lb in).

Fig 3: Identifying Center Console Tray & Screws

Courtesy of GENERAL MOTORS CORP.

Fig 4: Identifying Console Door Hinge & Air Vent Cover

Courtesy of GENERAL MOTORS CORP.

Install the cellular telephone docking station, if equipped with a Cellular phone, UV8. Refer to Cellular Telephone Docking Station Replacement in Cellular Communications.
Align the console lid and hinge assembly to the center console.
The center console door has alignment pins next to the top 2 hinge screws.
Install the top 2 console hinge screws (1).
Tighten: Tighten the screws to 1.6 N.m (14 lb in).
Install the air vent cover (2).

Fig 5: Identifying Rear Ashtray & Lighter Assembly Screws

Courtesy of GENERAL MOTORS CORP.

Install the console rear cover screws (2).
Install the rear ashtray and lighter assembly to the center console. Refer to Cigar Lighter Housing Replacement - Floor Console in Power Outlets.
Inspect the console compartment door for proper operation.