LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> Seville >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays, Gauges And Console >> Repair Instructions >> Closeout/Insulator Panel Replacement - Right (RHD) >> Installation Procedure

Installation Procedure

    Fig 1: View of Insulator
    GM105526Courtesy of GENERAL MOTORS CORP.
  1. Slide the insulator (2) over the top of the park brake bracket.
    2. Fig 2: View of Insulator Electrical Connectors
    GM105529Courtesy of GENERAL MOTORS CORP.
  2. Connect the electrical connectors (1,3).
    3. Fig 3: Identifying Insulator Fasteners
    GM105527Courtesy of GENERAL MOTORS CORP.
  3. Set the forward edge of the insulator onto the shelf on the carpeting at the front of the vehicle.
  4. Align the insulator with the floor duct at the HVAC module.
  5. Align the snap tab fasteners with the lower IP and push the insulator upward in order to engage the fasteners.
    6. NOTE: Refer to Fastener Notice in Cautions and Notices.
  6. Install the insulator fasteners (1) into the lower IP.

    Tighten:  Tighten the fasteners to 2 N.m (18 lb in).

scientia non olet · About LEMON Manuals