Installation Procedure

Fig 1: Identifying Insulator Electrical Connectors

Courtesy of GENERAL MOTORS CORP.

Set the forward edge of the insulator onto the shelf on the carpeting at the front of the vehicle.
Reconnect the electrical connectors (1,2).

Fig 2: Identifying Insulator Fasteners

Courtesy of GENERAL MOTORS CORP.

Align the insulator with the floor duct at the HVAC module.
Align the snap tab fasteners with the lower IP, and push the panel upward in order to engage the fasteners.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the insulator fasteners (1) into the lower IP.
Tighten: Tighten the fasteners to 2 N.m (18 lb in).