Test Description
The number(s) below refer to the step number(s) on the diagnostic table.
- 2: Lack of communication may be due to a partial malfunction of the class 2 serial data circuit or due to a total malfunction of the class 2 serial data circuit. The specified procedure will determine the particular condition.
- 3: The symptom list in Symptoms will determine the correct diagnostic procedure to use.
- 4: The presence of DTCs which begin with "U" indicate some other module is not communicating. The specified procedure will compile all the available information before tests are performed.
Diagnostic System Check - Audible Warnings
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Audible Warnings Schematics | |||
| 1 | Install a scan tool. Does the scan tool power up? |
Go to Step 2 | Go to Scan Tool Does Not Power Up in Data Link Communications |
| 2 |
|
Go to Step 3 | Go to Scan Tool Does Not Communicate with Class 2 Device in Data Link Communications |
| 3 | Select the display DTCs function on the scan tool for the following control modules:
Does the scan tool display any DTCs for the control modules listed above? |
Go to Step 4 | Go to Symptoms - Instrument Panel, Gages and Console |
| 4 | Does the scan tool display any DTCs which begin with a "U"? | Go to Scan Tool Does Not Communicate with Class 2 Device in Data Link Communications | Go to Step 5 |
| 5 | Does the scan tool display DTC B1000, B1004, B1007, B1009, B1390, B1556, B1652, B1656, B1658, or B1805? | Go to Diagnostic Trouble Code (DTC) List in Body Control Systems | Go to Step 6 |
| 6 | Does the scan tool display DTC B1327, B1328, B1513, B1514, B1982, B1983, P0560, P0562, P0563, P0615, P0621, or P0622? | Go to Diagnostic Trouble Code (DTC) List in Engine Electrical | Go to Diagnostic Trouble Code (DTC) List |