Installation Procedure

NOTE: Refer to Fastener Notice in Cautions and Notices.

Fig 1: View Of Console Door Hinge & Screws

Courtesy of GENERAL MOTORS CORP.

Fig 2: View Of Armrest Inner Trim Panel & Screws

Courtesy of GENERAL MOTORS CORP.

If equipped with UV8, Install the Cellular phone docking station. Refer to Cellular Telephone Docking Station Replacement (DeVille and DHS) or Cellular Telephone Docking Station Replacement (DTS) in Cellular Communications.
Install the console tray (2).
Install the console tray screws (1)
Tighten: Tighten the screws to 1.6 N.m (14 lb in).

Fig 3: View Of Center Console Tray & Screws

Courtesy of GENERAL MOTORS CORP.

The center console door has alignment pins next to the top 2 hinge screws.
Align the console lid and hinge assembly to the center console.
Install the console hinge screws (1).
Tighten: Tighten the screws to 1.6 N.m (14 lb in).
Install the inner auxiliary HVAC outlet (2).

Fig 4: View Of Inner Auxiliary HVAC Outlet & Screws

Courtesy of GENERAL MOTORS CORP.

Close the console compartment door.
Install the center console rear cover (3).
Install the console rear cover screws (1, 2).
Tighten: Tighten the screws to 1.6 N.m (14 lb in).

Fig 5: View Of Center Console Rear Cover & Screws

Courtesy of GENERAL MOTORS CORP.

Install the auxiliary HVAC control. Refer to HVAC Control Module Replacement - Auxiliary in HVAC Automatic.
Ensure proper operation of the console door.