LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.6 7 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Manual Transmission Clutch System) >> Repair Instructions >> Pilot Bearing Replacement (CTS-V) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Removing Clutch Pilot Bearing Using J 43276
    GM353275Courtesy of GENERAL MOTORS CORP.
  1. Remove the clutch. Refer to Clutch Assembly Replacement (CTS)  and/or Clutch Assembly Replacement (CTS-V) .
    2. IMPORTANT: When using the J 43276, always secure the J 43276-1 tool body using a wrench. Do not allow the J 43276-1 tool to rotate. Failing to do so causes damage to the J 43276-1 tool body.
  2. Remove the clutch bearing using the J 43276  .
    1. Install the J 43276-1 into the clutch pilot bearing.
    2. Using a wrench, secure the J 43276-1.
    3. Insert the J 43276-2 into the J 43276-1.
    4. Rotate the J 43276-2 clockwise into the J 43276-1 until the clutch pilot bearing is completely removed from the crankshaft.
    5. Rotate the J 43276-2 counterclockwise to remove the J 43276-2 from the J 43276-1.
    6. Remove the J 43276-1 from the tool body.
scientia non olet · About LEMON Manuals