LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.6 7 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Manual Transmission Clutch System) >> Repair Instructions >> Clutch Pedal Position Switch Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the closeout/insulator panel. Refer to Closeout/Insulator Panel Replacement - Left in Instrument Panel, Gages, and Console.
  2. Disconnect the clutch pedal position switch electrical connector.
    3. Fig 1: Pushing Clutch Position Switch Retaining Plate Locking Tabs
    GM802893Courtesy of GENERAL MOTORS CORP.
  3. Push the clutch position switch retaining plate locking tabs (2) toward each other.
    4. Fig 2: Sliding Retaining Plate
    GM802896Courtesy of GENERAL MOTORS CORP.
  4. Slide the retaining plate (1) past the locking tabs.
  5. Remove the retaining plate (1) from the clutch pedal position switch (2).
  6. Remove the clutch pedal position switch (2) from the clutch master cylinder push rod (3).
scientia non olet · About LEMON Manuals