LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.6 7 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Manual Transmission Clutch System) >> Repair Instructions >> Clutch Master Cylinder Replacement (CTS) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install the clutch pedal position switch to the clutch master cylinder. Refer to Clutch Pedal Position Switch Replacement .
    2. Fig 1: Inserting Clutch Master Cylinder Into Cowl
    GM802898Courtesy of GENERAL MOTORS CORP.
  2. With the clutch fluid reservoir connection at 2:00 position. Insert the clutch master cylinder into the cowl.
  3. Align the keys of the clutch master cylinder housing with the tabs on the clutch pedal bracket.
  4. Rotate the clutch master cylinder counter clockwise approximately 1/8 turn until fully seated. The clutch fluid reservoir hose connection will be at vertical 12:00 position when the clutch master cylinder is properly installed.
    5. Fig 2: Connecting Clutch Hydraulic Hose
    GM785890Courtesy of GENERAL MOTORS CORP.
  5. Connect the clutch hydraulic hose. Refer to Hydraulic Clutch Hose/Pipe Replacement (CTS-V)  and/or Hydraulic Clutch Hose/Pipe Replacement (CTS) .
  6. Install the coolant surge tank. Refer to Surge Tank Replacement (LHD M 35) and/or Surge Tank Replacement (RHD) and/or Surge Tank Replacement (LHD M 82 LY7) and/or Surge Tank Replacement (LHD M 82) and/or Surge Tank Replacement (LHD M35 LS6) and/or Surge Tank Replacement (LS6) in Engine Cooling.
    7. Fig 3: Installing Clutch Fluid Reservoir
    GM785889Courtesy of GENERAL MOTORS CORP.
  7. Install the clutch fluid reservoir to the fender reinforcement.
    8. NOTE: Refer to Fastener Notice in Cautions and Notices.
  8. Install the clutch fluid reservoir bolt.

    Tighten:  Tighten the bolt to 36 N.m (27 lb ft).

    9. Fig 4: Positioning Clutch Master Cylinder Push Rod To Clutch Pedal Pin
    GM802760Courtesy of GENERAL MOTORS CORP.
  9. Position the clutch master cylinder push rod to the clutch pedal pin.
  10. Push the clutch master cylinder push rod onto the clutch pedal pin to secure.
  11. Connect the clutch pedal position switch electrical connector.
  12. Install the driver side instrument panel insulator. Refer to Closeout/Insulator Panel Replacement - Left in Instrument Panel, Gages and Console.
  13. Bleed the clutch hydraulic system. Refer to Hydraulic Clutch Bleeding (CTS)  and/or Hydraulic Clutch Bleeding (CTS-V) .
scientia non olet · About LEMON Manuals