LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.6 7 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Engine Mechanical - 3.2L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Intake Manifold Cover Replacement - Left >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the oil filler spout by unlocking the tab and twisting counterclockwise.
    Fig 1: Expanded View Of Oil Filler Spout
    GM804903Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the following from the remote power steering fluid reservoir (1):
    • The vacuum brake booster hose
    • The wiring harness (2)
    Fig 2: Identifying Engine Wiring Harness & Remote Power Steering Fluid Reservoir
    GM785764Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the vacuum brake booster hose from the vacuum source.
  4. Remove the remote power steering fluid reservoir mounting bolts (1, 3) ONLY.
    Fig 3: Locating Remote Power Steering Fluid Reservoir Mounting Bolts
    GM785730Courtesy of GENERAL MOTORS CORP.
  5. Position the reservoir forward away from the cam cover.
  6. Disconnect the following from the front of the throttle body heater inlet hose/pipe bracket:
    • The camshaft position (CMP) sensor connector
    • The left knock sensor connector (1)
      Fig 4: Locating Left Knock Sensor Connector
      GM785856Courtesy of GENERAL MOTORS CORP.
    • The vacuum hoses
  7. Remove the left cover (1) from the cam cover (3).
    Fig 5: Expanded View Of Left Cover & Cam Cover
    GM918939Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals