LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.6 7 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Engine Mechanical - 3.2L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Engine Rear Cover Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the camshaft drive sprockets. Refer to Camshaft Drive Sprocket Replacement .
    2. Fig 1: Removing & Installing Timing Belt Tensioner Locking Nut, Washer & Pulley
    GM833133Courtesy of GENERAL MOTORS CORP.
  2. Remove the timing belt tensioner locking nut, washer and pulley.
    3. Fig 2: Identifying Knock Sensor Pigtail
    GM785857Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the knock sensor pigtail (1) from the bracket.
    4. IMPORTANT: The knock sensor pigtail is guided past the rear timing belt cover by several retaining clips.
    Note the positioning of the knock sensor pigtail.
  4. Remove the knock sensor pigtail from the retaining clips on the rear timing belt cover.
    5. Fig 3: Removing & Installing Rear Timing Belt Cover
    GM832743Courtesy of GENERAL MOTORS CORP.
  5. Remove the rear timing belt cover bolts.
  6. Remove the rear timing belt cover threaded pin (1).
  7. Remove the rear timing belt cover.
scientia non olet · About LEMON Manuals