LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.6 7 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Engine Mechanical - 3.2L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Engine Mount Bracket Replacement - Right >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the right catalytic converter. Refer to Catalytic Converter Replacement - Right (LA3, LY9) in Engine Exhaust.
  3. Remove the starter. Refer to Starter Motor Replacement (LA3, LY9) in Engine Electrical.
  4. Install a screw jack with a block of wood under the oil pan for support.
  5. Remove the right engine mount upper retaining nut.
    IMPORTANT: Ensure not to distort or bend the engine mount heat shield.
    Fig 1: View Of Right Engine Mount Upper Retaining Nut
    GM816388Courtesy of GENERAL MOTORS CORP.
  6. Remove the right engine mount bracket mounting bolts.
    Fig 2: View Of Right Engine Mount Bracket Mounting Bolts
    GM816392Courtesy of GENERAL MOTORS CORP.
  7. Remove the engine mount bracket from the vehicle.
scientia non olet · About LEMON Manuals