LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.6 7 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Engine Mechanical - 3.2L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Drive Belt Tensioner Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Position the drive belt tensioner and lower bolt to the engine as an assembly.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the upper drive belt tensioner bolt.

    Tighten:  Tighten the drive belt tensioner bolts to 35 N.m (26 lb ft).

    Fig 1: View Of Drive Belt Tensioner Bolts
    GM785757Courtesy of GENERAL MOTORS CORP.
  3. Install the drive belt. Refer to Drive Belt Replacement .
scientia non olet · About LEMON Manuals