LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.6 7 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Engine Mechanical - 3.2L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Crankshaft Pulley Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Removing & Installing Crankshaft Gear Bolt
    GM159205Courtesy of GENERAL MOTORS CORP.
  1. Coat the lip of the crankshaft front oil seal with a small amount of clean engine oil, to aid in installation.
  2. Install the oil pump collar fully into the crankshaft front oil seal.
  3. Install the crankshaft gear to the crankshaft.
    4. Fig 2: Identifying J 42065
    GM217371Courtesy of GENERAL MOTORS CORP.
  4. Mount the J 42065  to the crankshaft gear. See Special Tools and Equipment .
  5. Complete the following in order to install the new crankshaft gear bolt:
    1. Counterhold the crankshaft gear using the J 42065  . See Special Tools and Equipment .
      2. NOTE: Refer to Fastener Notice in Cautions and Notices.
      NOTE: Refer to Torque to Yield Bolts Notice in Cautions and Notices.
    2. Install the new crankshaft gear bolt using the J 42098  . See Special Tools and Equipment .
    3. Tighten the crankshaft gear bolt in sequence:

      Tighten: 

      1. Tighten the crankshaft gear bolt to 250 N.m (184 lb ft).
      2. Using the J 36660-A  , rotate the crankshaft gear bolt 45 degrees. See Special Tools and Equipment .
      3. Repeat the sequence turning the crankshaft gear bolt an additional 15 degrees.

  6. Remove the J 42065  from the crankshaft gear. See Special Tools and Equipment .
  7. Install the timing belt. Refer to Timing Belt Replacement .
scientia non olet · About LEMON Manuals