LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.6 7 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Engine Mechanical - 3.2L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Crankshaft Front Oil Seal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the crankshaft drive gear. Refer to Crankshaft Pulley Replacement .
    2. Fig 1: Identifying Self-Tapping Screw
    GM769023Courtesy of GENERAL MOTORS CORP.
  2. Carefully drill a small, shallow, pilot hole into the steel ring of the crankshaft front oil seal.
  3. Screw in a self-tapping screw.
  4. Use pliers to pull out the crankshaft front oil seal.
  5. Clean the sealing surface.
scientia non olet · About LEMON Manuals