LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.6 7 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Engine Mechanical - 3.2L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Crankshaft Balancer Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Removing & Installing Crankshaft Balancer
    GM217342Courtesy of GENERAL MOTORS CORP.
  1. Install the crankshaft balancer to the crankshaft sprocket.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the crankshaft balancer bolts.

    Tighten:  Tighten the crankshaft balancer bolts to 20 N.m (15 lb ft).

  3. Install the drive belt. Refer to Drive Belt Replacement .
  4. Remove the intake air resonator. Refer to Intake Air Resonator Replacement in Engine Controls-2.6L and 3.2L.
scientia non olet · About LEMON Manuals