Removal Procedure
WARNING: This page is about a different variant/trim than selected.
- Remove the following components according to the RPO code:
- LHD
- The air inlet grill panel. Refer to Air Inlet Grille Panel Replacement (LHD) or Air Inlet Grille Panel Replacement (RHD) in Body Front End.
- The fasteners securing the front air inlet panel assembly to the battery tray and cowl.
- The front air inlet panel assembly from the vehicle.
- RHD
The wiper motor module. Refer to Wiper Motor Module Replacement (LHD) or Wiper Motor Module Replacement (RHD) in Wipers/Washer Systems.
- LHD
- Disconnect the electrical connector (2) from the coil pack (1).
- Remove the heated oxygen sensor connector (1) from the bracket (3).
- Remove the bolt securing the surge tank outlet pipe to the vent housing-LHD ONLY.
- Disconnect the following from the crankcase vent housing (4):
- The crankcase ventilation fresh air hose (2)
- The crankcase ventilation dirty air hose (3)
- The engine wiring harness push retainer
- Remove the bolt (6) securing the following to the crankcase vent housing (4):
- The heated oxygen sensor connector bracket (5)
- The evaporative emission (EVAP) canister purge valve bracket (1)
- Remove the crankcase vent housing bolts.
- Remove the crankcase vent housing from the engine block.
- Plug the open ports to the crankcase, in order to prevent foreign objects from entering the engine.
- Clean and inspect the surface of the engine block and crankcase vent housing.