LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.6 7 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Engine Mechanical - 3.2L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Camshaft Drive Sprocket Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the timing belt. Refer to Timing Belt Replacement .
    2. Fig 1: Identifying Index Mark On Oil Pump Cover
    GM828921Courtesy of GENERAL MOTORS CORP.
  2. As a precaution, rotate the crankshaft counter clockwise using the J 42098  until 60 degrees Before Top Dead Center (BTDC). See Special Tools and Equipment .

    The 60 degrees BTDC point can be identified by the index mark on the oil pump cover, at this position the valves will not touch the pistons.

    3. Fig 2: Identifying J 42069-1 & J 42069-2
    GM345381Courtesy of GENERAL MOTORS CORP.
  3. Remove the camshaft drive sprocket bolt.

    The J 42069-1 and J 42069-2 will hold the drive sprockets in place while removing the bolts.

    Discard the camshaft drive sprocket bolt.

  4. Remove the J 42069-1 and J 42069-2.
  5. Remove the camshaft drive sprocket.
scientia non olet · About LEMON Manuals