LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.6 7 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Engine Mechanical - 3.2L) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Water Pump Installation

Water Pump Installation

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Removing & Installing Water Pump
    GM217345Courtesy of GENERAL MOTORS CORP.
  1. Apply silicone GM P/N 12345579, (Canadian P/N 1974984), to the water pump seal.
  2. Install the water pump seal.
  3. Install the water pump.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the water pump bolts.

    Tighten:  Tighten the water pump bolts to 25 N.m (18 lb ft).

scientia non olet · About LEMON Manuals