LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.6 7 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Engine Mechanical - 3.2L) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Water Crossover Installation

Water Crossover Installation

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Water Crossover, Bolts & Seals
    GM769013Courtesy of GENERAL MOTORS CORP.
  1. Install the water crossover lower seals (2) and water crossover (3).
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the water crossover upper seals (2) and bolts (1).

    Tighten:  Tighten the water crossover bolts to 30 N.m (22 lb ft).

scientia non olet · About LEMON Manuals