LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.6 7 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Engine Mechanical - 3.2L) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Intake Manifold Installation

Intake Manifold Installation

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Intake Manifold, Bolts & Seals
    GM217280Courtesy of GENERAL MOTORS CORP.
  1. Ensure the intake manifold flange seals (3) are in place and not damaged.
  2. Install the intake manifold (2).
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the intake manifold bolts (1).

    Tighten:  Tighten the intake manifold bolts to 20 N.m (15 lb ft).

scientia non olet · About LEMON Manuals