LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.6 7 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Engine Mechanical - 3.2L) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Engine Block Assemble (with K05)

Engine Block Assemble (with K05)

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Removing & Installing Blow-By Plate
    GM797547Courtesy of GENERAL MOTORS CORP.
  1. Install the blow-by plate.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the blow-by plate bolts.

    Tighten:  Tighten the blow-by plate bolts to 8 N.m (71 lb in).

    3. Fig 2: Removing & Installing Block Heater
    GM797548Courtesy of GENERAL MOTORS CORP.
  3. Install the O-ring onto the block heater.
  4. Install the block heater.

    Tighten:  Tighten the block heater to 60 N.m (44 lb ft).

    5. Fig 3: Removing & Installing Coolant Jacket Plugs
    GM797541Courtesy of GENERAL MOTORS CORP.
  5. Apply thread sealant GM P/N 12346004 (Canadian P/N 10953480) to the threads of the coolant jacket plugs.
  6. Install the coolant jacket plugs.

    Tighten:  Tighten the coolant jacket plugs to 65 N.m (48 lb ft).

scientia non olet · About LEMON Manuals