LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.6 7 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Engine Mechanical - 3.2L) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Camshaft Drive Sprocket Removal >> Tools Required

Tools Required

WARNING: This page is about a different variant/trim than selected.

J 42069  Timing Belt Alignment Kit. See Special Tools and Equipment .

    Fig 1: Identifying J 42069-1 & J 42069-2
    GM345381Courtesy of GENERAL MOTORS CORP.
  1. Install the J 42069-1 between camshaft drive sprocket 1 and 2 to hold the camshaft drive sprockets in place while loosening the bolt.
  2. Install the J 42069-2 between camshaft drive sprocket 3 and 4 to hold the camshaft drive sprockets in place while loosening the bolt.
    3. Fig 2: Installing Camshaft Drive Sprocket Bolts
    GM159009Courtesy of GENERAL MOTORS CORP.
  3. Loosen the camshaft drive sprocket bolts.
    4. IMPORTANT: Some of the camshaft lobes are under load from the lifters and may abruptly rotate with the locking tools removed.
  4. Remove the camshaft locking tools and carefully rotate the camshafts to release the lifter pressure from the camshafts, if applicable.
  5. Remove the camshaft drive sprocket bolts.
  6. Remove the camshaft drive sprocket washers.
  7. Remove the camshaft drive sprockets.
scientia non olet · About LEMON Manuals