LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.6 7 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Controls - 2.6L & 3.2L - Introduction) >> Repair Instructions >> Intake Resonance Switchover Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Locating Switchover Valve & O-Ring & Intake Air Resonator
    GM819414Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Ensure the O-ring is properly positioned to the switchover valve.
  1. Install the switchover valve and O-ring into the intake air resonator.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the intake resonance switchover valve bolts.

    Tighten:  Tighten the intake resonance switchover valve bolts to 8 N.m (71 lb in).

  3. Connect the vacuum hose to the intake resonance switchover valve.
  4. Install the intake air resonator. Refer to Intake Air Resonator Replacement .
scientia non olet · About LEMON Manuals