LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.6 7 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Controls - 2.6L & 3.2L - Introduction) >> Repair Instructions >> Intake Resonance Switchover Solenoid Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Intake Resonance Switchover Solenoid
    GM819412Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the following from the intake resonance switchover solenoid:
    • The electrical connector
      • IMPORTANT: Observe the proper positions of the vacuum hoses.
    • The vacuum hoses
  2. Remove the intake resonance switchover solenoid screws.
  3. Remove the intake resonance switchover solenoid from the intake air resonator.
scientia non olet · About LEMON Manuals