LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.6 7 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Controls - 2.6L & 3.2L - Introduction) >> Repair Instructions >> Intake Plenum Switchover Solenoid Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Locating Intake Plenum Switchover Solenoid Electrical Connector
    GM785855Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the following from the intake plenum switchover solenoid (2):
    • The electrical connector (1)
    • The vacuum hoses
    2. Fig 2: View Of Intake Plenum Switchover Solenoid Bolts
    GM819408Courtesy of GENERAL MOTORS CORP.
  2. Remove the intake plenum switchover solenoid bolts.
  3. Remove the intake plenum switchover solenoid from the intake plenum.
scientia non olet · About LEMON Manuals