LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.6 7 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Controls - 2.6L & 3.2L - Introduction) >> Repair Instructions >> Heated Oxygen Sensor (HO2S) Replacement Bank 2 Sensor 2 >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
    2. Fig 1: View Of Engine Harness Connector & Heated Oxygen Sensor Connector
    GM785791Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the heated oxygen sensor connector from the engine harness connector.
    3. Fig 2: Identifying Heated Oxygen Sensor
    GM785783Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Oxygen Sensor Notice in Cautions and Notices.
    IMPORTANT: Removal of the oxygen sensor is easier when the engine temperature is above 48°C (120°F).
  3. Remove the heated oxygen sensor using the J 39194  . See Special Tools and Equipment .
scientia non olet · About LEMON Manuals