LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.6 7 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Controls - 2.6L & 3.2L - Introduction) >> Repair Instructions >> Evaporative Emission (EVAP) Hoses/Pipes Replacement - Chassis/Canister >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of EVAP Hose Retainers
    GM818893Courtesy of GENERAL MOTORS CORP.
  1. Position the EVAP hose to the fuel tank.
  2. Install the chassis to canister evaporative emission (EVAP) hose to the following:
    • The body retainer (1)
    • The 3 retaining features (2) on the fuel tank
    • The retainer clip (3)
  3. Install the fuel tank. Refer to Fuel Tank Replacement .
scientia non olet · About LEMON Manuals