LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.6 7 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Controls - 2.6L & 3.2L - Introduction) >> Repair Instructions >> Engine Coolant Temperature (ECT) Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Partially drain the coolant system. Refer to Draining and Filling Cooling System (LA3, LY9) or Draining and Filling Cooling System (LY7) or Draining and Filling Cooling System (LS6) in Engine Cooling.
  2. Remove the wiper motor module in order to gain access to the engine coolant temperature (ECT) sensor. Refer to Wiper Motor Module Replacement (LHD) or Wiper Motor Module Replacement (RHD) in Wipers/Washer Systems.
    3. Fig 1: Identifying Engine Coolant Temperature (ECT) Sensor & Electrical Connector
    GM830543Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the electrical connector (3) from the ECT sensor.
  4. Remove the ECT sensor from the water crossover.
scientia non olet · About LEMON Manuals