LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.6 7 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Engine Controls - 2.6L & 3.2L - Diagnosis (DTC P0449 - P2010)) >> Diagnostic Trouble Codes >> DTC P0610 >> Test Description

Test Description

WARNING: This page is about a different variant/trim than selected.

The number below refers to the step number on the diagnostic table.

  1. 2:  A DTC P0610 indicates the ECM is not programmed.
DTC P0610

Step Action Yes No
1 Did you perform the Diagnostic System Check-Engine Controls? Go to Step 2  Go to Diagnostic System Check - Engine Controls
2  Program the ECM. Refer to Service Programming System (SPS) in Programming.
Is the action complete?		 Go to Step 3  -
3
  1. Clear the DTCs with a scan tool.
  2. Turn OFF the ignition for 30 seconds.
  3. Start the engine.
  4. Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text.
Does the DTC run and pass?		 Go to Step 4  Go to Step 2 
4 Observe the Capture Info with a scan tool.
Does the scan tool display any DTCs that you have not diagnosed?		 Go to Diagnostic Trouble Code (DTC) List System OK
scientia non olet · About LEMON Manuals