Diagnostic Aids
WARNING: This page is about a different variant/trim than selected.
- The following conditions may cause this DTC to set:
- Camshaft reluctor wheel damage
- Incorrect sensor installation
- The sensor coming in contact with the reluctor wheel
- Excessive air gap between the reluctor wheel and the sensor magnet
- A cracked or damaged sensor
- Foreign material passing between the sensor and the reluctor wheel
- The CMP sensor low reference circuit is shared with the Mass Air Flow (MAF) sensor, and the Engine Coolant Temperature (ECT) sensor.
- If an intermittent condition exists, refer to Intermittent Conditions .