Conditions for Running the DTC

WARNING: This page is about a different variant/trim than selected.

DTCs P0030, P0031, P0032, P0036, P0037, P0038, P0101, P0102, P0103, P0112, P0113, P0116, P0117, P0118, P0125, P0128, P0135, P0141, P0171, P0172, P0174, P0175, P0300, P0301-P0306, P0443, P0444, and P0445 are not set.
The Loop Status Bank 1 and Loop Status Bank 2 parameter is closed.
The Engine Speed parameter is between 1,200-3,000 RPM.
The Calc Converter Temp parameter is over 350°C (662°F).
The Volumetric Efficiency parameter is between 12-70 percent.
The purge solenoid valve has been commanded OFF for at least 10 seconds.
This diagnostic runs once per ignition cycle once the above conditions are met.