Conditions for Setting the DTC
WARNING: This page is about a different variant/trim than selected.
- The ECM detects that the affected HO2S 1 voltage is between 60-400 mV, when the same bank HO2S 2 voltage is above 499 mV for at least 10 seconds.
OR
- The ECM detects that the affected HO2S 1 voltage is 600-1080 mV, when the same bank HO2S 2 voltage is below 104 mV for at least 10 seconds.
OR
- The ECM detects that the affected HO2S 1 voltage has risen 16 times out of 24 samples when the heater is cycled OFF.