LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.6 7 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Manual Transmission - M35) >> Repair Instructions >> Shift Control Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Installing Shift Control Assembly
    GM801332Courtesy of GENERAL MOTORS CORP.
  1. Install the shift control assembly to the vehicle and clip the shift control assembly into the shift control adaptor plate.
    2. Fig 2: Connecting Shift Control Rod
    GM834520Courtesy of GENERAL MOTORS CORP.
  2. Connect the shift control rod (2) to the transmission and install the shift control rod pin (3).
  3. Connect the reaction arm (4) to the transmission and install the reaction arm pin (5).
  4. Install the shift control rod pin and reaction arm pin retaining clips (1).
  5. Raise the rear of the transmission to the original position.
  6. Install the transmission support. Refer to Transmission Support Replacement in Frame and Underbody.
  7. Remove the transmission jack.
    8. Fig 3: Installing Propeller Shaft Coupler
    GM803962Courtesy of GENERAL MOTORS CORP.
  8. Install the propeller shaft coupler (1) to the transmission flange. Refer to Propeller Shaft Replacement (Automatic Transmission) , Propeller Shaft Replacement (Manual Transmission) or Propeller Shaft Replacement (CTS-V) in Driveline/Axle.
  9. Install the exhaust system. Refer to Exhaust System Replacement (LA3, LY9) , Exhaust System Replacement (LY7) or Exhaust System Replacement (LS6) in Engine Exhaust.
    10. Fig 4: Installing Bolts Securing Shift Control Assembly
    GM785886Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  10. Install the bolts securing the shift control assembly to the shift control adaptor plate.

    Tighten:  Tighten the bolts to 9 N.m (80 lb in).

    11. Fig 5: Installing Sound Insulator Foam Block
    GM834525Courtesy of GENERAL MOTORS CORP.
  11. Install the sound insulator foam block into the console.
  12. Install the shift control knob/closeout boot. Refer to Shift Control Knob/Closeout Boot Replacement .
scientia non olet · About LEMON Manuals