LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.6 7 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Manual Transmission - M35) >> Repair Instructions >> Mainshaft Rear Oil Seal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Disconnecting propeller shaft coupler
    GM803962Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the propeller shaft coupler (1) from the transmission flange. Refer to Propeller Shaft Replacement (Automatic Transmission) , Propeller Shaft Replacement (Manual Transmission) or Propeller Shaft Replacement (CTS-V) in Driveline/Axle.
  2. Push the front propeller shaft toward the rear of the vehicle in order to release the propeller shaft coupler (1) from the transmission flange.
    3. Fig 2: View Of Flange Tool
    GM804354Courtesy of GENERAL MOTORS CORP.
  3. Install J 45012  to the drive flange.
  4. Remove the drive flange nut using J 29873  while holding the J 45012  .
  5. Discard the drive flange nut.
  6. Remove J 45012  from the drive flange.
    7. Fig 3: Removing Drive Flange From Transmission Output Shaft
    GM819957Courtesy of GENERAL MOTORS CORP.
  7. Remove the drive flange from the transmission output shaft using J 45019  .
    8. Fig 4: Removing Output Shaft Seal
    GM801798Courtesy of GENERAL MOTORS CORP.
  8. Remove the output shaft seal using J 23907  and J 26941 .
scientia non olet · About LEMON Manuals