LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine Mechanical - 3.6L (Ly7) (Repair Procedures -- 2 Of 5)) >> Repair Instructions (On-Vehicle Part 2 & Off-Vehicle - Part 1) >> On-Vehicle Repair Instructions - Part 2 >> Oil Pump Pipe and Screen Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Oil Suction Tube Seal & Oil Suction Tube
    GM1318091Courtesy of GENERAL MOTORS CORP.
  1. Install a NEW oil suction tube seal onto the oil suction tube. DO NOT reuse the old oil suction tube seal.
    2. Fig 2: View Of Oil Suction Pipe
    GM1210965Courtesy of GENERAL MOTORS CORP.
  2. Install the oil suction pipe.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the oil suction pipe bolts.

    Tighten:  Tighten the oil suction pipe bolts to 10 N.m (89 lb in).

    4. Fig 3: View Of Oil Pan Scraper And Bolts
    GM1210963Courtesy of GENERAL MOTORS CORP.
  4. Install the oil pan scraper.
  5. Install the oil pan scraper bolts.

    Tighten:  Tighten the oil pan scraper bolts to 10 N.m (89 lb in).

  6. Install the oil pan. Refer to Oil Pan Replacement .
scientia non olet · About LEMON Manuals