LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine Mechanical - 3.6L (Ly7) (Repair Procedures -- 2 Of 5)) >> Repair Instructions (On-Vehicle Part 2 & Off-Vehicle - Part 1) >> On-Vehicle Repair Instructions - Part 2 >> Engine Flywheel Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the transmission. Refer to Transmission Replacement (2.6L and 3.2L) or Transmission Replacement (3.6L (LY7)) in Automatic Transmission - 5L40-E.
  2. Remove the engine flywheel bolts and the flywheel. Refer to Engine Flywheel Removal .
    Fig 1: View Of Engine Flywheel
    GM902811Courtesy of GENERAL MOTORS CORP.
  3. Clean and inspect the flywheel. Refer to Engine Flywheel Cleaning and Inspection . If the flywheel teeth are damaged, inspect the starter for proper operation. Replace the starter if there is excessive wear or damage to the starter drive. Refer to Starter Motor Replacement (LA3, LY9) or Starter Motor Replacement (LY7) or Starter Motor Replacement (LS6) in Engine Electrical.
scientia non olet · About LEMON Manuals