LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine Mechanical - 3.6L (Ly7) (Repair Procedures -- 2 Of 5)) >> Repair Instructions (On-Vehicle Part 2 & Off-Vehicle - Part 1) >> On-Vehicle Repair Instructions - Part 2 >> Crankshaft Rear Oil Seal and Housing Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Removing & Installing Rear Oil Seal & Housing
    GM902808Courtesy of GENERAL MOTORS CORP.
  1. Install the crankshaft rear oil seal and housing. Refer to Crankshaft Rear Oil Seal and Housing Installation .
  2. Install the oil pan. Refer to Oil Pan Replacement .
  3. Install the engine flywheel. Refer to Engine Flywheel Replacement .
scientia non olet · About LEMON Manuals