LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine Mechanical - 3.6L (Ly7) (Repair Procedures -- 2 Of 5)) >> Repair Instructions (On-Vehicle Part 2 & Off-Vehicle - Part 1) >> Off-Vehicle Repair Instructions - Part 1 >> Drive Belt Removal >> Outer Drive Belt

Outer Drive Belt

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Removing & Installing Power Steering Reservoir Hose
    GM945797Courtesy of GENERAL MOTORS CORP.
  1. Compress and reposition the clamp on the power steering reservoir hose in order to remove the hose from the power steering pump.
  2. Remove the power steering reservoir hose from the power steering pump.
    3. Fig 2: Removing & Installing Power Steering Pump Reservoir
    GM945805Courtesy of GENERAL MOTORS CORP.
  3. Remove the power steering pump reservoir bolts.
  4. Remove the power steering pump reservoir.
    5. Fig 3: View Of Drive Belt Tensioner & Pulleys
    GM284263Courtesy of GENERAL MOTORS CORP.
  5. Insert a 1/2 inch drive ratchet into the outer drive belt tensioner.
  6. Rotate the drive belt tensioner clockwise.
  7. Remove the drive belt from around the drive belt tensioner.
  8. Slowly rotate the drive belt tensioner counter-clockwise.
  9. Remove the 1/2 inch drive ratchet.
    10. Fig 4: Identifying Outer Drive Belt
    GM945814Courtesy of GENERAL MOTORS CORP.
  10. Remove the drive belt from around the following:
    • Crankshaft balancer
    • Generator
scientia non olet · About LEMON Manuals