LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2004 >> CTS Base, 3.2 N >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine Mechanical - 3.6L (Ly7) (Repair Procedures -- 2 Of 5)) >> Repair Instructions (On-Vehicle Part 2 & Off-Vehicle - Part 1) >> Off-Vehicle Repair Instructions - Part 1 >> Drive Belt Removal >> Inner Drive Belt

Inner Drive Belt

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Drive Belt Tensioner & Pulleys
    GM284263Courtesy of GENERAL MOTORS CORP.
  1. Insert a 1/2 inch drive ratchet into the inner drive belt tensioner.
  2. Rotate the drive belt tensioner clockwise.
  3. Remove the drive belt from around the drive belt idler.
  4. Slowly rotate the drive belt tensioner counter-clockwise.
  5. Remove the 1/2 inch drive ratchet.
    6. Fig 2: Identifying Inner Drive Belt
    GM945818Courtesy of GENERAL MOTORS CORP.
  6. Remove the drive belt from around the following:
    • Crankshaft balancer
    • Air conditioning compressor
    • Drive belt tensioner
    • Power steering pump
    • Water pump pulley
scientia non olet · About LEMON Manuals